INTRODUCTION
1.Button Pull Tester ,Fastener Pull Test Stand,to determine the holding or breaking strength of prong-ring attached snap fasteners onto garments. Consists of an Upper Snap Clamp, a Lower Fabric Clamp & Force Gauge mounted on a stand.
The snap component is gripped by the Upper Snap Clamp and the garment is fixed to the lower Fabric Clamp. By turning the Top Flywheel, the operator can apply a specific force and the holding force or the breaking strength can be recorded.Capability can be enhanced with clamps & accessories for testing of other Snaps, Jean Buttons, Four Hole Buttons & Garments Accessories such as Zippers, Bows, Appliqué, Toggles, Hooks/Bars,and D-Rings,amongst others.
2.The detachment of a snap or other parts may be classed as small parts; whilst broken small parts may require sharp point & sharp edge testing. As a result, additional testing equipments may be recommended, such as :
TN2008 Sharp Point Tester
TN2018 Sharp Edge Tester
TN11308 Button Impact Tester
TECHNICAL PARAMETERS
1.TONNY Dimension : 280×230×735 mm
2.Gross weight : 30 kg
STANDARDS
GB 6675,16 CFR 1500,ASTM D7142-2,ASTM F963,EN 71 Part1,CPSC,ISO 8124,M&S P115A,etc
CONFIGURATION and ORDERING INFOMATION
Code No. | Description | ● Standard / 〇 Optional | Photo |
11298-A-1 | The Base : used to install the tension gauge, fixture and fixed sample and test operation. | ● |
|
TN2418 | 30 kg Imada Force Gauge FB-30K : display the reading of force. | ● |
|
11298-2 | Calibration Weight(15 LB) : routine checking the accuracy of Imada Force Gauge. | ● |
|
11298-A-3 | Lower Fabric Clamp,Level Arm Locking : fix the fabric specimen with buttons firmly,flatly & constantly so that the fabric slippage can be minimized. | ● |
|
TN2408-2 | Upper Long Nose Vise Grip : mainly used for trouser hooks and other smaller accessories. | ● |
|
TN2408-6 | Upper Three Pronged Grip : can adjust Jaw size, suitable for different sizes of buttons decorations. Generally used for testing four-hole buttons & jeans . | ● |
|
TN2408-11 | Upper Grasp Button Grip : designed to grip the grasp button or larger buttons,e.g. Jeans button or plastic buttons up to 30 ligne. | ● |
|
TN2408-7 | Upper Snap Grip : testing concave buttons with five claws. | ● |
|
TN2078-B | Transparent Small Parts Cylinder : to test whether the garment accessories are classified “Small Part” or not in accordance with EN 71,CPSC,ASTM F963 ,ISO 8124 etc. | ● |
|
TN2408-8 | Upper Stud Grip : testing the convex button with five claws.
| 〇 |
|
TN2408-5 | Upper Two Pronged Grip : can adjust Jaw size, suitable for different sizes of buttons decorations. | 〇 |
|
TN2408-1 | Seam Tension Grip : testing the seam `s pulling force. | 〇 |
|
TN11298-4 | Zipper Test Kit : to test for the zipper stops & D-rings. | 〇 |
|
Copyright @ TONNY INTERNATIONAL
E-mail : 15015204254@163.com
